Superabrasive LAVINA 38GR -X, User Manual

Page: 14 / 58

Superabrasive
Owner’s Manual Original Language – Lavina
®
38GR-X 08/2017
14
Figure 4.5 Figure 4.4
4.OPERATION
PRELIMINARY CONTROLS
Inspect the working area as explained in the safety instructions. For wet use, fill the water tank with the electrical cable
disconnected. Connect the vacuum extractor and ensure that the vacuum hose is clear and able to follow the machine
easily. Plug in the machine and make sure that the power cord is free to follow the working direction of the Lavina
®
38GR-X.
CONTROL OF THE WATER FLOW
The operator can choose
where the water sprays
with the red lever (Fig. 4.2-
1). When the lever is
perpendicular to the valve,
water sprays in front of the
machine (Fig 4.1). When
the lever is parallel to the
valve, water sprays under
the cover of the machine.
One valve (Fig. 4.2-2) controls the flow from an external water supply, which can be connected via a 3/4" water tube at
the quick connection (Fig. 4.2-3). The other valve (Fig. 4.2-4) should be closed to the external water supply to prevent
water leaking into the tank.
The flow regulating valve located on the tank (Fig. 4.3) can increase or reduce the water flow to the working area (in
front of the machine or under the main head cover of the machine).
ADJUSTING AND MOUNTING TOOLS
Mount the tools only after ensuring that there is enough
diamond bond material left. Be sure that the plates are
always clean before mounting. WARNING: Always secure
the“Quickchange” pads with the security plate (Fig.4.4), lock
with the tool holder key (Fig.5.3). Diamond tools with Velcro
are attached on three foam plates of 13.2 inch (Fig.4.5). The
foam plates are mounted on the key lock (butterfly). Always
use the tool holder key (Fig.5.3).
Figure 4.1
Figure 4.2 Figure 4.3