28
8.5 DISMOUNTING/MOUNTING THE ENGINE
Separate head from carriage (see previous chapter). Remove front (Fig. 8.5.1) and back belt protection (Fig. 8.5.2). Loose the
motor base plate (Fig. 8.5.3), release the tension device (Fig. 8.5.4), and take out the belt (Fig. 8.5.5). Take off the engine (Fig.
8.5.6).
Reassemble in the same manner. (Fig.
8.5.7), Tension the belt with bolt (4) on
(fig. 8.5.7) or (fig. 8.5.4) The belt
tension can be tested with a Frequency
tension Tester Optibelt 3 TT- (190-
200Hz) .
ATTENTION:
NEVER “OVER” TENSION THE BELT, THE BELT WILL BE
DESTROYED AND IT WILL NEVER RECOVER ITS ORIGINAL
TENSION
Figure 8.55.3
Figure 8.5.2
Figure 8.5.4
Figure 8.5.1
Figure 8.5.7
Figure 8.5.5
Figure 8.5.6
