LED Strobe Light Head
WIFI-CON
User Manual
Important: Read all instructions prior to installation.
STSC-x6
Safety and Notes
Installation and Operation
Parts Included
Accessories
Specifications
1 - LED strobe light head
1 - mounting bracket
1 - hardware kit (to attach strobe head to mounting bracket)
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533 superbrightleds.com
STSC-x6
Voltage
12-24 VDC
Current Draw
600 mA (0.6 A) @12 VDC
IP Rating
IP67
Wire Length
15 in. (381 mm)
Recommended Fuse Rating
1A /Light Head
Operating Temperature
-22°–122° F(-30°–50° C)
Strobe Switch (AMSB-2M-PT)
Fuse Holder (WMFH)
Fuse (MAF-x)
• To reduce risk of electric shock, ensure that battery is
disconnected before performing any installation procedures.
• When linking multiple lights with a common wire, make sure
to select wire appropriately sized for intended load and run
of the wire.
• Avoid looking directly into lamp when illuminated.
Setting Group
Strobes can be set in two groups, so they flash in an alternating
pattern. Strobes in same group will flash together.
1. Prior to installation and with strobe grounded, apply power to red
and yellow wire simultaneously. Light will flash once for group 1
and twice for group 2.
2. Remove yellow wire from power and then momentarily reapply
power to change group. Light will remain in its set group until the
process is repeated.
Changing Flash Patterns
1. Once each light is set to desired group, complete main power
and ground wiring.
2. Connect common wire that runs from yellow wire on each light
to a momentary switch.
Note: Supply side of switch should only be connected to
fused power.
3. Apply main power to turn strobes on, then use momentary
switch to cycle through patterns.
Flash Patterns
Rev Date: V1 04/05/2019
Pattern
Pattern Name
1
Six Flash
2
Quad Flash
3
Double Flash
4
Six Flash (Speed)
5
Single Flash-R65
6
Triple Flash
7
Double Flash (Speed)
8
Quad Flash (Speed)
9
R/L Flash
10
Double Flash (R/L)
11
Six Flash (R/L)
12
Riple Flash (R/L –Speed)
