
10
Before every shift or 8-hour operation, check loosened, twisted, hardened, or cracked cable
and wire.
Before every shift or 8-hour operation, check lost or damaged connectors.
Before operation, tighten, repair, or replace any loosened or damaged cable, wire and
connector. If the cable or wire is loosened or twisted, don’t operate the machine.
Repair switch
Before everyday operation, check the function of key switch and engine emergency stop
switch. If there is any unusuality, repair at once. In
case of fire, if you can’t stop engine, it will aggravate
firepower, and may cause GBH.
Clean out inflammable materials
Spilled fuel, stored breeze, and other inflammable
materials may cause fire. Keep the machine clean
every day to prevent fire.
1.35 EMERGENCY EXIT
Emergency exit mark is shown in right figure
:
When there is an emergency and the operator can not get out of the cabin, take the small hammer
hung on the wall in cabin to break the window with emergency exit mark to leave the machine.
The cabin safety structure can not be repaired after damage but it can be replaced with other
qualified safety protective structures.
1.36 Noise and vibration
The emission sound pressure level at the operator's and the sound power level of machine are
measured according to ISO 6396:2008 considering the method of ISO 3744:2009 under the
operation condition required in EU Directive 2000/14/EC and 2005/88/EC, the test results as
below:
The A-weighted emission sound pressure level at the operator's position is:
L
pA
= 80 dB, which is less than 80 dB required in EN 474-1:2006+A1:2009.
The sound power level of the machine is
:
LWA= 93 dB, which complied with the limit of
2000/14/EC and 2005/88/EC
1. Pay attention not to be hurt by the splashing objects while
breaking the window with a certain distance to the breaking hole
for safety.
2. The breaking hole should be big enough for operator to get out
(according to operator’s own condition) and the hole should have
no sharp spines for safety.
Summary of Contents for SWE20F 2019
Page 101: ...99 8 ATTACHMENT 8 1 20FNELECTRIC DRAWING...
Page 102: ...100 8 2 20FHYDRAULIC DRAWING...