35
When battery is used or charged, it will
produce explosive gas. Avoid flame or spark
being close to battery. Electricize battery
in a well-ventilated area. Place the machine
on dry & hard ground, not on steel plate,
otherwise it may produce spark accidentally.
Never connect anode and cathode directly,
otherwise it will cause short circuit.
When start engine, the operator must sit on
the operation seat to control machine.
Start engine in cold weather
1)
Keep pilot valve control cut off pole to the lock position, pilot joystick and travel pole at the
neutral position.
2)
Turn key switch to "ON" position.
3)
Right-turn key switch to "HEAT" position, about 30 seconds later, indicator light comes on,
it means the preheating work is finished.
4)
Key switch continue to right-turn to "START" position to start engine, switch will
automatically return to "ON" position when release key.
Adjust engine rev
When accelerograph handle is lifted to upmost and engine runs at full load; lower handle to
bottommost, engine runs at minimum load; adjust accelerograph between upmost and
bottommost to control engine rev, and also you can screw handle to adjust accelerograph
imperceptibly.
Stop engine
1
）
Lower the bucket to ground.
2
）
Place the accelerograph handle to minimum load position for about 5 minutes.
3
）
Screw key switch to “OFF” position to stop engine, and take out key.
4
）
Pull pilot control lever to LOCK position.
Use assistant battery
FIG. 3-6
Don’t stop engine directly when it is fully loaded,
stop engine after 5 minutes minimum load operation
to unload the heat load and avoid possible damage
to engine. If engine stops with load, remove load
and start engine at once. Operate engine for 1
minute at half speed before loading.
Summary of Contents for SWE20F 2019
Page 101: ...99 8 ATTACHMENT 8 1 20FNELECTRIC DRAWING...
Page 102: ...100 8 2 20FHYDRAULIC DRAWING...
