2nd
I. Precautions
Before using this system, please carefully read the following precautions to ensure that the system can safely and
reliably work.
Before powering on the transmitter and receiver, make sure the antennas
are in good connection.
Before powering on, make sure distance between two antennas( TX & RX) longer than 10meters, or the
electrical level will be too high to damage the RX.
Selecting an appropriate installation location and try your best to make the RX antenna in higher place and its
directivity is in open air.
Do not disassemble the antenna until the power is turned off
Make sure the whole power supply system complies with the relevant technical requirements
Try your best to make the video source far away from the TX and avoid the parallel between video source cable
and TX antenna
Before using, make sure the power full . Because with low power the communication will be unstable and the
video will be discontinuous.
Please do not open the case to do some changes without any permission and guidance of supplier.
Please do not allow any metal objects to enter into the system shell
Remark
：
The system must be operated in a dry and ventilated environment.
The system settings are configured before leaving the factory. Do not change the parameters randomly.