Doc. Title
Author
Page of Pages
ST300/340 OPERATION MANUAL
– LATAM
HG.Park
6 of 146
Concerning
Doc. No.
Rev.
Date
Features and How to set parameters
1.41
26 May. 2015
Suntech International Ltd.
Confidential Document
1. Introduction
The ST300 (or ST340/ST340LC or their variation models such as ST300B, ST300V, ST300R, ST300A, ST300P,
ST300F, ST300H, ST300C, ST300K, ST340LC, etc.) is a vehicle tracking and controlling device. It is designed to
collect location data through GPS technology, various vehicle conditions through event lines, and interact remotely
with its server by using GSM/GPRS technology.
In order to make the vehicle tracking system work, device should be configured and installed properly on a vehicle
whose geographical position and/or state is desired to be remotely monitored and/or controlled.
Following this “Introduction Chapter” (i.e. Chapter 1.), the Operation Manual is organized as below.
Chapter 2. Overview
This chapter covers fundamental features of the device.
Chapter 3. Communication string format (
‘Command’ and ‘Report’)
This chapter gives descriptions on the two (2) formats, Command (all the formats received by device) and
Report (sent from the device).
Chapter 4. Configuration
This chapter gives users explanation on how and what parameters are required to be set in configuring
device.
This manual describes setting commands which can be sent with following three options;
Option 1: Setting by PC.
Option 2: Setting by GPRS.
Option 3: Setting by SMS.
Practically special program (named as “SyncTrak”) is used for setting. It enables setting much easier and
multi-setting possible in PC environments.
Chapter 5. Tracking and route deviation parameters
This chapter gives users explanation on how these parameters need to be set if user wants to enable the
device to track moving of vehicle along the routes predefined by the user.
Chapter 6. Reporting to server
This chapter covers when and what reports are sent back to the server by device.
Chapter 7. Command for general use
This chapter describes what commands the server sends to its device.
