Doc. Title
Author
Page of Pages
ST300/340 OPERATION MANUAL
– LATAM
HG.Park
133 of 146
Concerning
Doc. No.
Rev.
Date
Features and How to set parameters
1.41
26 May. 2015
Suntech International Ltd.
Confidential Document
<Notes>
ON: Activation.
OFF: Deactivation.
Enable: Enable or Disable by setting.
X:Please, do not care.
For setting method, please refer to
“Motion Sensor Parameter Settings”.
[Caution]:Basically, the device checks any motions in parking mode(Ignition Off). It does not care about the enable
flags such as COLL_EN or SHOCK_EN. This means that, if the device senses any motion (movement) created in
the power down mode, it will exit from the power down mode as if a creature would wake up from sleeping
suddenly. So, if you want to check the power down mode to save power consumption of the backup battery, DO
NOT give any impacts to the vehicle.
9-6. Protection of Vehicle Battery
For a period of duration that the vehicle has been in a parking mode for a long time by consuming vehicle
’s battery
down to a very low level, the device starts entering the Deep Sleep Mode automatically. This situation happens
because the device intends to prevent
vehicle’s battery from wasting power. In this case, the device alerts with
ALERT_ID 14 before entering the deep sleep mode, and exits from the deep sleep mode either when ignition line
goes to
‘ON’ or until the voltage level is increased sufficiently.
The vehicle
’s battery level for protection can be changed by making a Command. Refer to Voltage control
parameters section.