13
ТЕХНИЧЕСКИ ПАСПОРТ. ИНСТРУКЦИЯ за МОНТАЖ и ЕКСПЛОАТАЦИЯ
ТЕХНИЧЕСКИ ПАСПОРТ. ИНСТРУКЦИЯ за МОНТАЖ и ЕКСПЛОАТАЦИЯ
INSTALLATION and OPERATION MANUAL
INSTALLATION and OPERATION MANUAL
INSTALLATION and OPERATION MANUAL
INSTALLATION and OPERATION MANUAL
6.4. Connecting air ducts
TDA boilers can be equipped with air
ducts (ducts). Install the ducts to the
boiler so that:
- Do not overload the product;
- allow access and removal of all
accessories;
- preventing recirculation of air
between the inlet and outlet of the
machine;
- are protected from accidental
penetration of external bodies in the
unit.
When connecting air ducts, the
higher the evaporator fan speed can
be switched. The length of the ducts
shall not exceed 3 m for the inlet and
5 m for the outlet, for a minimum
diameter ø150.
6.5. Condensation pipe connection.
During the operation of the heat pump,
condensate water is discharged and drains
into the sewage through a condensate
pipe. The latter must be connected to the
drainage pipe so as to ensure unhindered
drainage of the condensed water.
6.2. Connection to the water supply
network
- Ensure that the anode is installed during
installation.
- The connection schemes in this manual
are exemplary. When connecting the
product to a solar system or boiler it
is necessary to consult and supervise
a technical person authorized by the
manufacturer.
- When connecting to the water supply
network, we recommend that you secure
at least one shut-off valve, non-return
valve, safety valve and expansion vessel.
6.3. Connecting to the electricity mains
Before starting any operation,
make sure the power is off!
- The electrical connection to the control
panels must be carried out by a person
authorized by the manufacturer in
accordance with the wiring diagram.
Ensure that the frequency and voltage
of the data plate corresponds to the
power grid to which the appliance will
be connected. When connecting to the
mains, all safety rules must be observed.
Do not use adapters, couplers,
and extensions when plugging
the heat pump into the mains!
- It is the duty of the installer to ensure
the power supply with a separate fuse in
the dashboard.
- It is the duty of the installer to
ensure the power supply with a
separate fuse in the dashboard.
