SunSynk SUNSYNK-8K-SG01LP1, Installer Manual

Page: 46 / 78

Page | 46 Hybrid Inverter | Installer Manual
5.10. Battery Setup Page
To configure battery settings, click on the BATTERY icon and then on ‘Batt type’.
What this page displays:
ƒ
Battery capacity in (Ah) – For non-BMS-batteries the range allowed is 0-2000Ah, while for
lithium-ion the inverter will user the capacity value of the BMS.
ƒ
Max battery charge current (Amps).
ƒ
Max battery discharge current (Amps), which should be 20% of the Ah rating for AGM only.
For Lithium, please refer to the battery manufacturer documentation. Note: This is a global
max. discharge current for both ‘grid-tied’ and ‘backup’ modes of operation and if the cur-
rent exceeds this value inverter will shut down with an overload fault.
ƒ
TEMPCO settings - Temperature coefficient is the error introduced by a change in tempera-
ture.
What you can do from this page:
ƒ
Use battery voltage for all settings (V).
ƒ
Use battery SOC for all settings (%).
ƒ
No battery: tick this box if no battery is connected to the system.
ƒ
BMS setting.
ƒ
Active battery - This feature will help recover a battery that is 100% discharged by slowly
changing from the solar array. Until the battery reaches a point where it can change normally.