Dual Color Wall Mounted Touch ZigBee Remote Controller
09.ZG2TU.04781
LED indicator
Function introduction
Important:
Read All Instructions Prior to Installation
Front side
Back side
19.4 mm
43.58 mm
6
5
.5
8 m
m
AC Power input
L
L
8
3
.0
0 m
m
ZigBee controller
N
N
AC POWER INPUT
Press and hold down to
decrease light intensity
Press and hold down to
increase light intensity
CCT color wheel, slide touch
to select color temperature
ON/OFF button, click to turn
ON/OFF all, press and hold
down to search and pair to
ZigBee network or factory
reset the controller
Press and hold down to get
warmer and warmer white
Press and hold down to get
cooler and cooler white
Scene button, press and
hold down to save a scene,
click to recall the saved
Note: This remote supports 1
group for binding max. 30
lighting devices. Each group
can save and recall 6 scenes.
Product Data
Transmission Range
(free field)
30m
Operating temperature
0-40°C
Relative humidity
8% to 80%
Dimming Range
0.1%-100%
Power Supply
100-240V AC
Operation Frequency
2.4GHz
Dimensions
120x75x29.1mm
Protection Type
Ip20
• ZigBee CCT remote based on ZigBee 3.0
• Full touch glass interface, smooth CCT and light
intensity control
• Enables to pair ZigBee lighting devices via touchlink
commissioning without coordinator
• Supports find and bind mode to pair with ZigBee
lighting devices in the same network
• Supports 1 group for binding max. 30 lighting devices
• 2.4 GHz global operation
• Transmission range up to 30m
• Compatible with universal ZigBee Gateway products
• Compatible with universal CCT ZigBee lighting
devices
•
DO NOT install with power applied to the device.
•
DO NOT expose the device to moisture.
Safety & Warnings
Operation
1.This ZigBee CCT remote is a wireless transmitter that communicates with a variety of ZigBee
compatible systems. This transmitter sends wireless radio signals that are used to remotely control a
compatible system.
2.This ZigBee remote supports 1 group for binding max. 30 lighting devices and enables to control
tunable white ZigBee lighting devices.
3. Zigbee Network Pairing through Coordinator or Hub
(
Added
to
a
Zigbee
Network
)
Step 1:
Remove the remote from
previous zigbee network if it has
already been added to it, otherwise
pairing will fail. Please refer to the part
"Factory Reset Manually".
Step 2:
From your zigbee controller or
hub interface, choose to add device or
accessory and enter Pairing mode as
instructed by the controller.
Step 3:
Press and hold down until LED
indicator turns on.
Step 4:
Immediately short press to
search nearby network, indicator
flashes every 1 second, 20 seconds
timeout if there is no network. Indicator
will then blink 5 times quickly for
successful pairing.
ZigBee Clusters Supported by This Remote Are As Follows:
Input clusters:
•
Basic
•
Power Configuration
•
Identify
•
Diagnostics
Output clusters:
•
Identify
•
Scenes
•
On/off
•
Level control
•
Color control
•
Ota
