Z-Wave Gateway Controller
09.288WNZV.04159
Wiring diagram
12V DC power input
Method 1:Configure the gateway to your home network, then connect your smart phone with your home network router
Function introduction
Important:
Read All Instructions Prior to Installation
Radio protocol
Z-Wave Plus
Operation Frequency
868.40MHz/908.40MHz/921.40MHz
Operating temperature
0-40°C
Relative humidity
8% to 80%
Dimensions
110x85x24.2mm
• This Z-Wave gateway controller works with Z-Wave lighting devices and secondary controllers.
• Free APP is available for IOS or Android smart phones or tablets.
• Can be controlled by smart phones or home network.
• Waterproof grade: IP20.
Product Data
•
DO NOT install with power applied to device.
•
DO NOT expose the device to moisture.
Safety & Warnings
Power Supply
12VDC
Green LED indicator:
Power normal
Red LED indicator:
Z-Wave signal
Blue LED indicator:
WiFi connected
Ethernet
12V DC power
input
Router
Method 2: Connect your smart phone directly with the gateway
12V DC power
input
1-
LED
2-
3-
4-
Z-Wave Controller
Prog.
1-
LED
2-
3-
4-
Z-Wave Controller
Prog.
1-
LED
2-
3-
4-
Z-Wave Controller
Prog.
Note
: When the hub
is configured to home router,
use the button to reset WiFi
setting to enable to control
directly through the hub
network again.
WiFi Reset switch: press and
hold down for 10S then release,
the blue WiFi indicator will go
off and go on again, WiFi setting
will be factory reset.
WiFi
(Reset)
