Quick Setup
Guide
© 2020
Sun
RADON; P/N 1032013, Rev C; 5 March 2020
Plug In
Plug the Lüft into a wall AC outlet.
• Keep the Lüft upright as shown above. The AC plug prongs can be
rotated 90 degrees.
• Choose a location that is draft-free (away from direct air such as air
conditioning vents), and where the Lüft can remain plugged-in and
undisturbed.
Tip: Replace an existing nightlight with the Lüft.
LED
The front panel displays one of the
following default colors:
• Yellow—warning
• Red—alert
• Green—ok
• Blue—nightlight
The LED colors, warning/alert thresholds, and nightlight start and stop times are
configurable in the Lüft app for each Lüft.
Warm Up
After the Lüft is plugged in and the monitor has completed its self-test, the LED
may display yellow or red until initial stabilization is complete.
•
30 minutes
: Initial indoor air quality (IAQ) readings (eCO2, tVOC,
Temperature, Pressure, and Humidity) are available.
•
90 minutes
: First radon sensor readings are available and all six sensors start
reporting hourly.
After the first plug in, the Lüft will self-calibrate in the first three hours and then
continue to optimize over the next 7 days.
