Sunnydaze Decor WAR-191, Owner'S Manual

Page: 10 / 11

OPERATION INSTRUCTIONS
Lighting and Setting Control for Gas
Before lighting, make sure the valve knob is in the “OFF” position.
1. From the OFF position, push in and turn control knob counter-clockwise to the
LOW position.
2. Always perform a leak test before lighting the burner. See page 4
3. Hold a lit match within ¼” to the lava logs as shown on below picture, until the
burner is lit. If burner fails to light, turn to OFF. Wait 5 minutes before attempting
to re-light.
4. Turn control knob to desired heat setting, LOW or HIGH.
Shut-down for Gas
1. Turn the control knob gently to “OFF” position.
2. Disconnect and remove the gas tank when the gas fireplace is not in use.
MAINTENANCE INFORMATION
1. Adjust the control knob to reach different height for flame.
2. If in raining day, burner should be turned off, and put the cover on the burner.
Vinyl cover should not be put on this fireplace until the fireplace is cooled down.
Do not light or use gas unit if lava rocks are wet, ensure lava rocks are
completely dry before igniting as intense heat could cause the rock to crack.
3. It is recommended that the fireplace be stored indoors in freezing temperatures.
The cylinder must be disconnected and removed from the appliance before the
appliance can be stored indoors.
4. The propane canister must be stored outdoors and never close to the operating
unit.