2. If the water does not flow out of the fountain, it may be caused by kinked or loose water tubes, make sure water tubes
are connected properly.
ASSEMBLY PICTURES
ASSEMBLY INSTRUCTIONS
DO NOT allow the pump to run dry!
Fig5
Fig 3
Step 1: Place the base pedestal and the large basin on a level surface. route the pump’s power cord downwards
through the resin tube in large basin. Lay the pump in the bottom of the large basin.And then route the pump’s
power cord through the base pedestal, the cord exits through the slot in the bottom of base pedestal.,Lastly align
the large basin with base pedestal, insert the large basin and twist clockwise to lock in place securely. (pls
refer to the fig. 1,2,3)
Step 2: Route the water tube of the assembled topper downwards through the assembled large basin. Connect
the water tube to the outlet nozzle of pump. Make sure the connection is tight.insert the assmbled topper and
twise clockwise to lock in place securely. (pls refer to the fig.4,5)
Step 3: Fill the large basin and small basin with water. Make sure the pump is completely submerged in water.
Step 4: Plug the pump power cord to the wall outlet to run the fountain.
Fig4
Be careful not to spill water onto the plug of the pump.
Fig 1
Fig 2
Summary of Contents for LZH-131
Page 3: ......
