3
TROUBLESHOOTING
• Ensure the pump is fully submerged under water. Add water to the
basin as necessary.
• Check to make sure the power outlet is working; if in doubt about
electrical connections, consult a certified electrician.
• Check the pump and tubing for obstructions.
• Check the flow control on the body of the pump as it may need to be
adjusted to achieve the desired flow rate.
• If the light is not working, ensure the cables are fully connected and the
seal is adequately tightened (do not over-tighten).
• If water is not flowing within several moments of the fountain being
plugged in, unplug the power supply for a few moments and plug it
back in. The pump may have air bubbles in the filter, which can prevent
water from circulating properly.
USE & CARE
• For indoor use only.
• Keep fountain out of reach of children and pets.
• Keep power cord away from all heat sources. Do not place electrical
cords in areas with high temperatures.
• Check the water level frequently to ensure the pump remains fully
submerged; never allow the pump to run dry as it will burn out the motor.
• Only use water in this fountain; distilled water is recommended to
prevent mineral buildup.
• Periodically change the water to keep the water, fountain and pump
clean. Remove scale and buildup regularly.
DO NOT use harmful additives such as bleach, chlorine, etc.
DO NOT use anything abrasive to scrub the fountain.
• Always shut off the power supply before cleaning and maintaining the
fountain and the recirculating pump.
• Take care when handling the pump; only pick it up by the body of the
pump, never the power cord.
Any modification to the product or failure to follow recommended care
will void the product warranty.
IMPORTANT INFORMATION
2
NOTE:
The water tubing is built into the fountain. Take care when handling the water tube; detaching the
water tube from the fountain will damage the fountain and void the product warranty.
ASSEMBLY:
1.
Connect the shorter cable on the pump to the LED light cord that is inside
the fountain. If the cords are already connected, check connection and
tighten the plastic collar. Connect the pump to the water tube and place
the pump inside the fountain.
2.
Run pump power cable out the back of the fountain. Align the cable
with the groove in the access panel cover, as shown.
3.
Twist the access panel cover to secure it to the back of the fountain.
4.
Fill the fountain with enough water to keep the pump fully submerged
during operation.
5.
Connect the AC adapter to the power cord and plug it into a properly
grounded GFCI outlet.
2
1
4
5
Note
: When first used, there may be air in the pump.
It may take several minutes for trapped air to escape, allowing water to flow.
3
