Serial Flash Programmer[S550-SFWv3] Operation Manual
103
8.2.
Stand-alone Initialization
You can initialize data that is stored in the S550-SFWv3 internal memory on unit basis for security purposes.
The followings are the procedures for initialization.
*For initialized settings (factory settings), see “9.6 Initialized Settings (factory setting) List”.
*Initialization takes 1 to 2 minutes.
①
Connect the S550-SFWv3 main unit and target board
・
Connect S550-SFWv3 and the target board with the target connecting cable.
*For connection in stand-alone mode, see “4.2 Connection for Stand-alone Programming / Stand-alone Initializing”.
②
Power ON
・
Turn on the target board.
③
Confirm S550-SFWv3 start up
・
For the LED and buzzer status at the startup, see “9.2 LED Status List” and “9.3 Buzzer Sound List”.
④
Start Initializing
・
Press the “START” switch and hold it for 5 seconds to start initializing.
・
When initialization is started, all LEDs will be turned off, center display will be off and a series of short beeps
(“pip, pip, pip, pip...) sounds.
⑤
Initializing complete
・
After a beep “peep” sounds once, ”_”,”_” is displayed on the center display when initializing is complete.
