Quick installation
Sunmaster XS6500
English
Mastervolt International B.V,
P.O.Box 22947, NL-1100 DK Amsterdam, The Netherlands.
Tel.:
+31-20-3422100
Email:
Web:
www.mastervolt.com v1.0 070507EN
6
Close the connection compartment; Steps:
1
Tighten the two Philips screws (a)
2
Tighten the cable glands (b)
a
b
4
Loosen the two Phillips screws (a) and the two
clips (b) at the bottom side of the cabinet. Then
remove the bottom plate of the Sunmaster.
.
b
.
a
See chapter 3.6 for specifications of the solar
system. Make sure the DC-Switch is in the
OFF position. Then connect the string cabling
to the Sunmaster
7
Please turn page for commissioning instructions
SOLAR 1
SOLAR 2
3
Fix the mounting bracket to the wall
Then place the Sunmaster over the mounting
bracket and then move it downwards until it is
locked by the mounting bracket
This section provides a brief overview
of a basic stand-alone installation of
the Sunmaster XS6500.
5
See chapter 3.4 for specifications of the AC
wiring. Feed the AC wiring through the left
hand cable glad of the bottom plate and
connect the wiring to the screw terminals
1
However; please review the entire manual for
additional features and connection diagrams and to
ensure best performance and years of trouble-free
service.
All electrical systems (DC and AC)
must be disconnected from any
power source during the entire
installation! Use isolated tools!
2
Read safety instructions (chapter 2
of the user’s manual)