Adjustment on solar panel angle
According to different altitudes area and actual
environment, solar panel can be adjusted to
get the max sunshine
Solar
panel
can
be
adjusted within
135°horizontally
ON DIP
1 2 3 4
BLACK
RED
Solar Panel
GND
SLR(+12V)
INSTALLATION OF SOLAR BATTERY CABLE
As figure, pass the solar panel connecting cable
through the cable slot on back of detector and
connect it onto the relevant terminals on PCB
(Take care of polarities)
Note: please do lead cable according to above instruction,
don't drill holes to lead cable on top/back/side of detector,
otherwise it will damage the water-proof structure and
cause false alarm or malfunction.
2.Open the front cover: release the bottom screw
anticlockwise by a plus-screw-driver(no need to twist
out from cover), lift out the cover from bottom and then
turn on the power switch, red LED will flash for 40
seconds as warm-up, when LED stops, walking test can
be performed. (Please refer to following content on other
setting). Then, close the cover as figure and tighten the
screw. (Refer to below figure for details)
1.Loose the bottom
screw with cross-type
screw driver
1
2.Disclose the covers
from bottom
4.Make good alignment of
bottom parts of front and
bottom covers, and then press
down the top part of covers,
detector can be closed well.
p
o
w
er
s
w
it
ch
3.Turn on the power
switch
ON DIP
1 2 3 4
-1
+1
0
1.Drill a hole on wall and insert the rubber stopper into the
hole, fasten the detector by 3 screws.
Warning: this terminal can only be input with
5- 5.5VDC power or our solar battery, illegal
voltage might cause permanent damage to detector.
3.Decomposingsteps
INSTALLATION GUIDE
Even though Detector can accommodate outdoor severe environments, the following factors
shall be avoided during install-ation in order to get the reasonable detection:
No direct facing
cold/hot source
Mount on a secure and
stable base/object
electrical interferences
Keep away from strong
Incorrect Installation
(with pet immunity lens)
Don't install on a tree
WALL FASTENING
In order to get the maximum detection range, please install detector at 2.1m height and adjust
PCB position to “0” mark vertically. However, detector can be installed at 4m superlatively.
Please guarantee that there is no source of interference nearby and the front view of detector
is wide and clear.
Keep away from high
pressure power
Avoid moving vehicles
Place without enough
sunshine such as eave
and umbrage etc
Low height, short distance
2m
1.5m
3m
2.6m
0m
1.5m
3m
4.5m
6m
7.5m
9m
10.5m
0m
Suitable height
2m
1.5m
3m
2.6m
0m
1.5m
3m
4.5m
6m
7.5m
9m
10.5m
0m
On installation height
Recommended installation height is 1.8-2.4m
Too high to be with blind area
2m
1.5m
3m
2.6m
0m
1.5m
3m
4.5m
6m
7.5m
9m
10.5m
0m
Detection distance might
be shortened to movement
from these directions
Lowest sensitive
Most sensitive
On installation angle
Detection is with mechanical difference to intrusion
angles
Door
Unreasonable
installation position
Door
Best installation
On installation position
Detection is not sensitive
to intrusion from window
in this way
Detector is sensitive to
intrusion from door and
windows in this way
X
Detector
X
X
X
AD H
UGGE
R
R
O
X
X
X
X
W
in
d
o
w
W
in
d
o
w