Sunjoy Fant L-DN1308SCO, Owner'S Manual, Page: 8 / 11

8 of 11
OFF
HIGH
MAX
BAS
ARRET
LOW
OPERATION
LEAK TEST
1- Make sure the control knob is on the
“OFF” position.
2- Make sure the gas cylinder is correctly and securely connected to the pressure regulator, without
over tightening it.
3- Turn on the gas cylinder valve. Apply 50% soap and 50% water solution to the gas hose and
connections between the control knob and gas cylinder.
4- If something is leaking, you will see bubbles form. In case of leaks, turn off the gas supply, undo the
leaking connection, re-connect it and try again. If the leak persists, consult Customer Service Center for
assistance.
5- If the connection is sound, continue to the next step.
IGNITE LIGHTING
1- Make sure control valve is OFF.
2- Turn on gas tank valve.
3- Press in and turn control valve knob counterclockwise
to High to ignite. See the figure to the right.
4- If burner is lit, do not stop pressing in the control valve knob for
a minute to heat the thermocouple.
5- When control valve knob is released, the burner should be lit. If not, turn control valve knob
clockwise to OFF. Wait 5 minutes after completing Step 3 before attempting to re-ignite.
6- Press in and turn control valve knob to desired heat input, HIGH ~ LOW.
!!!WARNING!!!

Do not use an open flame to check for leaks.

Do not smoke during testing.

Do not test indoors.

A leak check must be performed whenever the gas cylinder is replaced.
Fig 6