sunjoe SWD4000, Operator'S Manual

Page: 8 / 16

8
Operation
m
WARNING!
This equipment incorporates parts such
as switches, motors or the like that tend to produce arcs or
sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive
liquids or vapors, as electrical devices produce arcs or sparks
which can cause a fire or explosion – do not use at filling
stations or anywhere gasoline is stored or dispensed.
St Stopping
Do not switch on the wet/dry vacuum until it has been
completely assembled. Before switching on the unit, always
check the power cord for signs of damage. Use only intact
cords.
m
WARNING!
Damaged cords pose a severe risk of injury.
Replace damaged cords immediately.
m
WARNING!
Before switching on the wet/dry vacuum,
make sure that it is not in contact with any foreign objects.
1. Make sure the filters are installed before starting.
2. Make sure the power head and the suction hose are
installed properly and locked securely.
3. Install the desired brush attachment onto the end of the
hose. Use the extension tubes if needed.
4. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the rating plate.
Plug the power cord into the outlet (Fig. 4). If an extension
cord is used, make a knot with the two cords as shown in
Table 1.
5. To start the unit, turn the ON/OFF switch to the ON
position (Fig. 5), as indicated.
6. To stop the unit, turn the ON/OFF switch to the OFF
position (Fig. 5), as indicated.
7. To adjust the strength of the airflow, push the sliding block
on the attachment handle up or down (Fig. 6).
8. To use the blower function, make sure the unit is turned
off. Then remove the hose from the air inlet hole and
insert into the blower flap by depressing the dual locking
buttons. Push firmly to secure (Fig. 7).
Operating Tips
This electric wet/dry vacuum is designed to clean hard
surfaces. It is only suitable for vacuuming wet or dry, light
materials. The vacuuming of heavy materials such as metal,
stones, branches, broken glass is expressly excluded.
m
WARNING!
Use the wet/dry vacuum only in daylight or
good artificial light.
• Make sure the power head is properly installed and
secured when using. Make sure each lock is secured.
Failure to properly secure the locks could cause the power
head to release from the tank.
• Double check to make sure the filters are not broken or
torn. Do not use filters that are broken or torn. Handle the
filters carefully when removing and installing.
• To reduce the risk of hearing loss associated with sound
level(s), hearing protection is required.
• Always direct the cord backwards, away from the unit.
• This unit is intended for indoor use only. Do not use this
unit outdoors.
Fig. 4
Power cord
OFF
ON
Fig. 5
ON/OFF
switch
Blower
flap
Fig. 6
Sliding
block
Attachment handle
Fig. 7
Blower
flap
Hose
connector
Dual locking
buttons