10
Operation
This lawn mower is intended for private residential use to cut
grass in small lawns and gardens. This lawn mower is not
intended to cut grass in public parks, playing fields, farms, or
forests. Do not use this lawn mower for any application other
than that for which it is intended.
Adjusting the Cutting Height
This electric lawn mower is equipped with a 3-position height
adjustment system to tailor grass cutting heights of 0.98 inch,
1.77 inch, and 2.56 inch. To change the cutting height of the
grass, follow the instructions below.
m
WARNING!
Before making these adjustments,
disconnect the power supply to the lawn mower and wait until
the rotating blade has come to a complete standstill. Wearing
gloves is recommended due to the close proximity of the
cutting blade.
ALWAYS FOLLOW ALL SAFETY PRECAUTIONS AND
RECOMMENDATIONS LISTED PREVIOUSLY IN THIS
MANUAL.
1. Power
off and unplug the lawn mower.
2. The height adjustment slots are behind each wheel. To
adjust the height, place the lawn mower on its side. Pull
the wheel lever out of the original slot, and insert it in
desired slot by moving the wheel on each side (Fig. 8).
3-Position Height Adjustment:
(1) 0.98 in. (25 mm)
(2) 1.77 in. (45 mm)
(3) 2.56 in. (65 mm)
3. Reconnect the power supply to the lawn mower and
resume normal use.
NOTE:
Make sure to adjust the two wheel levers in the
same slot on each side to avoid an uneven cut.
St Stopping
Do not switch on the lawn mower until it has been completely
assembled. Before switching on the unit, always check the
appliance cord and the extension cord for signs of damage.
Use only intact cords.
m
WARNING!
Damaged cords pose a severe risk of injury.
Replace damaged cords immediately.
m
WARNING!
Before switching on the lawn mower, make
sure that it is not in contact with any foreign objects. Keep
your hands and feet a safe distance away from the rotating
mower blade and the ejector opening. Failure to comply with
these warnings can result in severe personal injury.
IMPORTANT: Do not start the lawn mower in tall grass.
1. Place the unit on a level lawn surface.
2. Push a loop of the extension cord through the slot on the
extension cord restraint holder from the opposite side and
around the cord restraint hook. Insert the appliance cord
into the extension cord (Figs. 9 – 10).
NOTE: Do not plug the extension cord into the outlet until it
had been secured with the extension cord restraint holder and
connected to the lawn mower's appliance cord. Only use a
UL-rated extension cord for outdoor, all-weather use. Do not
use an extension cord over 100 ft (30 m). See Extension Cord
Chart on page 3.
Fig. 8
Height
adjustment slot
Wheel lever
Wheel lever
Height
adjustment slot
Fig. 9
Extension cord
restraint hook
Slot
Extension
cord
Fig. 10
Extension
cord
Appliance
cord
