63
step 4
Tap “Load default” and the password inputting window appears.
Tap “Load default” and the password inputting window appears;
-- -- E
En
nd
d
9.13 Checking Firmware Version
User can view the firmware version of LCD and DSP as follows:
step 1
Tap “Function” from the default menu.
step 2
Tap “Set-parameter”.
step 3
Tap “Sys-parameter” after entering the correct password.
step 4
Tap “Language & Firmware Ver.” and enter into the language and firmware version
sub-menu.
step 5
The firmware versions of LCD and DSP are displayed at the bottom of the page.
-- -- E
En
nd
d
9.14 Parameters of LCD
9.14.1 Communication Parameters
Improper communication parameter configuration may lead to communication
failure!
Follow strictly the instructions of the plant staff in configuring the
communication parameters.
Set the communication address and protocol through the LCD screen when the
hardware connection is complete and the device is energized.
Proceed as follows to set the communication parameters:
step 1
Tap “Function” from the default menu.
step 2
Tap “Set-parameter”.
step 3
Tap “Com-parameter” after entering the correct password.
•
Set parameter from the Address interface for setting the address.
•
Set parameter from the Serial Port Parameter interface for baud.
•
Set parameter from the Network Parameter interface for network communication.
-- -- E
En
nd
d
System Manual
Summary of Contents for SG4950HV-MV
Page 2: ......
