30
step 1
Remove the bottom cover of the inverter.
step 2
Take out the plate 1 and plate 2 in the scope of delivery, slide the two plates on the
bottom of the inverter and fix them.
step 3
Take out the C-shaped plate, and fix the plate to the bottom of the inverter.
step 4
Reinstall the bottom cover of the inverter.
During installation, M6x16 screw are used for tightening, and the tightening
torque is 5~7N.m.
-- -- E
En
nd
d
5.6
Clearance Requirement
The minimum reserved clearances around the inverters are shown in the following
figure.
System Manual
