Sungrow SG125HX, User Manual

Page: 57 / 103

47
O Ou utte err D Diia am me ette err D D((m mm m))
S Se ea all
4.5~6 c
6~12 a+b
12~18 b
step 3 Strip the insulation layer of the Ethernet cable with a wire stripper, and insert the signal
wires to the RJ45 connector(Pin 3 and Pin 6 are for communication connection). Crimp
the RJ45 connector with a crimping tool.
step 4 Insert the RJ45 connector to the RJ45 jack.
step 5 If other wiring operations need to be performed on the communication board, finish the
wiring operations before performing the following steps. If otherwise, continue to
perform the following steps.
step 6 Install the junction box, see
"
Install the Junction Box
"
.
step 7 Pull the cable gently to make sure it is secured, tighten the swivel nut clockwise.
-- -- E En nd d
User Manual 5 Electrical Connection