Sungrow EMS200, User Manual

Page: 23 / 53

User Manual
5. Electrical Connection
17
E
Item Definition Note
A Screw M4
B Spring washer ——
C Flat washer ——
D OT terminal ——
E Grounding hole of the local
controller ——
6.6 Power Supply Connection
The local controller supports DC24V DC input or AC100 to 240V (50/60HZ) AC
input. This section will take the AC power supply for example.
Step 1 Prepare power cables and phoenix terminal. Specifications of the AC &
DC cables are shown in the following table:
Cable Recommended cross-sectional area
AC cable Cross-sectional area: 1mm
2
to 1.5mm
2
DC cable Cross-sectional area: 0.75mm
2
to1mm
2
Step 2
Remove the phoenix terminal at the power supply port of the local
controller, and crimp the power supply terminal.
Step 3
Insert the power supply terminal to the corresponding DC/AC power
supply port.
DC（UPS）
AC