USER’S MANUAL
4
DIRECT USE WITH 12V DC CAR PLUG ADAPTOR
PLUG THE INCLUDED CAR PLUG ADAPTOR INTO THE CIGARETTE LIGHTER SOCKET ON YOUR
VEHICLE (TRUCK OR BOAT), INSERT THE ADAPTOR PLUG INTO THE LOWER DC JACK OF THE
SPOTLIGHT. TURN LIGHT ON USING SWITCHES.
FUSE RATING INSIDE THE CAR PLUG ADAPTOR: 10A 125V/250V
TO REPLACE THE FUSE:
1. Unscrew the top cover.
2. Pour out the fuse inside and
replace a new one.
3. Screw back the top cover to secure.
WARNINGS
• Lens of the halogen spot-
light is very hot during
operation
• Never block lens and reflector
during operation
• Do not shine directly into eyes
• To reduce the risk of electric shock,
unplug the unit and allow to cool before
attempting any cleaning and replacement
• To reduce risk of uncoverable damage, replace the bulb and battery with same rating only
BULB REPLACEMENT
1. Take off the front rubber cover.
2. Unscrew and remove the spotlight cover.
3. Carefully remove the lens and the rubber ring, then, take out the reflector.
4. Release the bulb guarding wires and replace the bulb with a new one.
5. Re-assemble the guarding wires, put back the reflector, rubber ring and the lens.
6. Secure the spotlight cover with screws and replace the front rubber cover.
BATTERY REPLACEMENT
1. Release the rear cover locks.
2. Remove the rear cover and pull out the battery.
3. Disconnect the terminals and replace the dead battery with a new one.
4. Replace the rear cover and the locking buckles.
Note:
The female connector must be connected to the lead of the battery correctly, red wire to positive (+) lead and
black wire to negative (-) lead. REVERSE POLARITY WILL DAMAGE THE UNIT.
IMPORTANT
Never leave battery discharged, recharge battery immediately after discharging. Recharge battery every 3 months
even the unit is not used.