Bi-Spectrum Radiometric Detector
User Manual
Device Installation
Issue V1.0 (2019-10-08)
15
Figure 3-7
Install the magnet bracket
Locking screw
Nut
Bracket nut
Step 4
Connect the multi-head combination cable to start up the camera.
Step 5
Adjust the universal rod of the bracket to adjust the camera angle, tighten the bottom
bracket nut and tighten the locking screw on the bracket to complete the angle
adjustment.
----End
3.2.2 Magnet Installation
Step 1
Open the label 2 in the positioning label and attach it to the mounting position on the
wall. Drill the hole in the small round hole of the positioning label with the drill bit
and insert the expansion rubber into the hole.
Step 2
Take out the camera and the magnet bracket, install the magnet bracket on the back of
the camera, and fix it with the PWM3×6 screws, as shown in Figure 3-8.