PXIe-700 User Guide
Page 4
Rev. 1.7
Sundance Digital Signal Processing Inc.
4790 Caughlin Parkway 233, Reno, NV 89519-0907, U.S.A.
Tel: +1 (775) 827-3103, Fax: +1 (775) 827-3664, email:
© Sundance Digital Signal Processing Inc 2016.
1
MMCX
User
Table 1 - High Speed Transceivers
2.6 HPC FMC
The board has an
HPC FMC connector for IO daughter cards. A total of 144 IO’s are connected
to the FPGA out of which 136 IO’s can be used as 68 differential pairs and 8 IO’s are single
ended. There are two differential clocks pins connected to the FPGA.
As mentioned in section 2.5, 10 high speed serial links from the FPGA are available on this
connector.
Note: Please see appendix for pinout.
2.7 LEDs
There are 6 LEDs present on this board. Their function and power on default values is
described below:
LED
USAGE
Power
ON
Default
D1
FPGA/DONE
OFF
D2
FMC_PG_C2M
ON
D3
USER
OFF
D4
USER
OFF
D5
USER
OFF
D6
USER
OFF
D7
USER
OFF
Table 2
– LEDs
Note: D7 is optional and populated instead of D3 and D4.
Note: Rev 3.0 of the board comes up with D3
– D6 as ON when it should be OFF on power up.
2.8 Switches
There is one switch, SW1, on the component side of the board. It has the following settings:
SW1
Control
1
Flash_25
2
Flash_24
3
Factory use
