Page 11
980™ Series
4.3
Location for the SunSmart™ 2.0 System
IMPORTANT!
Choose an installation site with the front control panel
side pointing towards your home’s Wi-Fi router.
CAUTION:
You must make sure that the spa control panel side
has a clear unobstructed line-of-site of the home Wi-Fi router. This
action ensures maximum signal strength between the spa and your
home’s Wi-Fi router.
Verify your home router’s Wi-Fi strength
at the proposed spa location. Front side of
spa must point towards your home’s Wi-Fi
router in your home as illustrated, Figure
4.3a. Stand near the proposed front control
panel side of the spa with your cell phone,
then login to the internet using your home
Wi-Fi router signal (not 3G or 4G) and verify
results as follows:
If the home Wi-Fi router signal is strong
(3-4 bars) and Internet access is stable,
the proposed installation site is a good choice. Visit our
website, www.SundanceSpas.com, for more information.
If the home router’s Wi-Fi signal is weak and Internet access is slow or
produces an error, the proposed installation site is not a good choice.
• It may be necessary to choose another spa installation site.
• Relocate your home Wi-Fi router closer to the spa.
• Install a “repeater” device in the room closest to the spa to boost the
home’s router Wi-Fi signal at the proposed spa installation site.
System and Wi-Fi Router Requirements
a. The hardware for the SunSmart 2.0 communicates over a 2.4 GHz
home network supporting 802.11b/g wireless technology.
Note:
The system
does not
support 802.11 ac/n. If your Wi-Fi router
is either 802.11 ac or n, it may work with the module if it supports
802.11b/g. The hardware
does not
support 5 GHz networks.
b. Standard wireless setup supports only home network routers
configured to use open (no security) or WEP/WPA/WPA2.
c. Wi-Fi signal strength of -60 dBM or better is highly suggested to
ensure non-interrupted cloud service.
d. The wireless access is not supported on the following systems
• Guest networks/Hotspots that use a portal page to login.
• Enterprise access points configured to require certificates or
some other form of enterprise authentication (aka “802.1X”,
“RADIUS”, or “WPA/WPA2 Enterprise”).
e. The App is only compatible with Android or Apple Phones.
•
Always make sure you have the latest operating system for your
phone.
Note:
Router ports 3197 and 3199 need to be open.
Home WiFi
Router
6:4
5
Auto
100
Figure 4.3a
Summary of Contents for Claremont 980 Series
Page 1: ...P N 6530 397D Rev A 980 Series Owner s manual Kingston Claremont...
Page 6: ......
Page 88: ...Page 82 980 Series...
