Page 73
880 SERIES
4.
Notes for iPod mode
In iPod Mode, the play/pause function works.
•
In iPod Mode, the RDM function does not work.
•
In iPod Mode, press RPT button only can play the current track
•
repeatedly. If RPT function is activated, press seek up/down button
could not select the next or previous track, it could only go back to
the beginning of the current track and begin to play again.
22.7
docking your iPod Music Player
1.
docking Your iPod
The Docking Station for iPod is compatible with
all dockable Apple iPod models.
To Install an Apple iPod:
A. Open Docking Station door (A) as outlined
in step 12 (page 68).
B. Center iPod over Docking Station Interface
Port, then gently press downward as shown
(B). DO NOT FORCE!
C. Close Docking Station door as shown (C),
then press firmly on door directly above
door release latch (15) until you hear an
audible “click”.
WArNiNG:
riSk OF eLeCTriCAL SHOCk HAZArd
exiSTS ANd eQUiPMeNT dAMAGe!
Never install or remove iPod while hands are wet or while
sitting partially immersed or fully immersed in spa!
CAUTiON
: Never leave iPod in Docking Station when
spa is not is use to prevent damage from outdoor elements!
Never spray Docking Station with pressurized water hose for
any reason! Damage to iPod or spa stereo system caused
by water intrusion is not covered under the manufacturer
warranty! Damage to Docking Station port or iPod due to
excessive force or improper alignment during installation or
removal from Docking Station is not covered under warranty.
2.
Setting Up The iPod for Use
A. Select and play preferred song/album/playlist prior to docking
iPod.
B. Press “MODE” button on stereo receiver or wireless remote until
display reads “IPOD.”
Note:
USB Docking Station is similar to the iPod Docking Station
operation.
