Page 57
880 SERIES
if your stainless handrails shows signs of rusting you should:
Wash with fresh water (a good detergent won’t hurt).
•
Clean with a good car chrome polish.
•
Wax with an automotive or fiberglass wax.
•
You should never:
Clean with chlorinated cleaners or scouring powders.
•
Use sand paper, “Scotch Brite”, Brillo pads, or similar abrasive
•
products.
Clean with muratic or hydrochloric acids. Vinegar is ok, but it won’t
•
do much to remove rust.
16.0 Troubleshooting - display Messages
There are a number of unique functions designed into your Sundance hot
tub to protect it from damage and/or to aid in troubleshooting. Following
is a listing of all the possible messages along with their meanings:
MeSSAGe
MeANiNG
Overheat Protection (Heater is deactivated, filter/
circulation pump is activated). Water temperature
is above acceptable limits.
dO NOT eNTer THe
WATer
! Remove hot tub cover to speed cooling.
See “Water is too hot” (page 60). If condition
persists, contact your Sundance Spas dealer or
qualified service technician.
If the hot tub water is more than -7°C cooler than the
temperature setpoint, jets pump #1 and heater will
automatically activate to provide freeze protection.
The hot tub will stay in this mode until the water
temperature reaches 15 degrees below the set
temperature. No corrective action is necessary.
FLOW SWITCH (Heater is deactivated. The filter/
circulation may also be deactivated). Proper flow of
water is inhibited or a flow switch has malfunctioned.
Check for proper water level and for clogged filter
(pages 49-50). Contact your Sundance Spas dealer
or qualified service technician.
*Note:
This message can also appear if the pump has not regained
prime after the hot tub has been drained and refilled. If you suspect that
this is the case, see the instructions on page 59 under “pump does not
operate and icon does.”
WArNiNG:
riSk OF HYPerTHerMiA
(OVer-HeATiNG) CAUSiNG SeVere
iNjUrY, BUrNS, Or WeLTS.
!
*
