Page 29
880 SERIES
11.0 Operating instructions
Your Sundance
®
hot tub has a touch-sensitive control panel, massage
selector valves and air control knobs located on the top rim of the hot
tub (Figures F-J, pages 24-28). These controls let you operate many of
the special functions of your Sundance
®
hot tub. By familiarizing yourself
with the following information, you will be able to gain the full benefit
afforded by the various functions of your hot tub.
11.1
View Button
Pressing this button inverts the main four-digit display on the
Command Center’s LCD screen to allow easy reading from
either inside or outside the hot tub.
11.2
Air injection
When the
Air
button is pressed, the air blower forces air
through the injectors located in the seats and footwell. The
bubbles symbol on the button appears on the LCD whenever the air
blower is on. An electronic timer automatically turns the air blower off 20
minutes after it was turned on.
Note:
The air blower automatically activates for 1 minute at the start of
the clean-up cycle at 12:00 (Noon). This clears the lines of the air injector
system to help ensure that all water is exposed to sanitizer. This cycle is
non-programmable.
11.3
Activate jets Pump 1
This button controls jets pump #1. Press once to turn on jets
pump #1. Press a second time to turn pump off.
11.4
Activate jets Pump 2/Pump 3
On two pump models, this button controls jets pump #2. Press
once to turn on jets pump #2. Press a second time to turn
pump off.
On three pump Maxxus models, this button controls both jets
pump #2 and jets pump #3 in the following sequence:
1. Press once to turn on jets pump #2.
2. Press a second time to turn on jets pump #3.
3. Press a third time to turn off jets pump #2.
4. Press a fourth time to turn off jets pump #3.
Note:
Anytime a jet pump has been manually activated, it will
automatically turn off after approximately 20 minutes. If at this time you
desire more jet operation you may simply turn the pump(s) back on.
