www.suncolighting.com
(844) 334-9938
CUSTOMER SERVICE
SALES
163 W Cochran St,
Simi Valley, CA 93065
Still having trouble? Contact us!
SUNCO’S WRAPAROUND 5”
Install Guide and Manual
EASY INSTALLATION
Junction Box Installation
Turn off circuit breaker that provides power to
the light switch for the recessed lights.
If replacing a fixture, remove existing fixture and
make a sketch of wiring configuration (by color) or
mark wires with masking tape for identification.
Remove the diffuser from the lamp base.
Open the junction box and take out the cables
from the lamp base, connect the wires:
•
Live to Live (black);
•
Neutral to Neutral (white);
•
Ground to Ground (yellow/green).
Secure the wires with the wire nuts, and fold
them into the junction box.
Mounting surface must be able to support
the weight of the fixture.
Depending on your lighting plan, space the
fixtures accordingly.
•
Link up to 4 Fixtures.
Install the two screws (AA) into the junction
box.
Leave 1/4” of screws exposed to accommodate
lamp base.
Attach the Lamp Base to the junction box by
aligning the holes on the Lamp Base with the
screws on the junction box.
Turn Lamp Base clockwise to lock into place
and tighten screws to ensure the fixture is
secure.
Turn Power OFF
1.
4.
6.
7.
2.
3.
5.
8.
9.
Wattage
Voltage
Suitable for Locations Ingress
Lumens
40W
120/277V
Damp
4500
Weight
Warranty
3.50lbs
7 years
SPECIFICATION
WARNING
10.
11.
AA
Junction
Box
A
A
Required Tools:
Drill, Ladder, Tape
Measure, Pencil, Stud Finder
All electrical connections must be in accordance with local and
National Electric Code (N.E.C.) standards. Consult a qualified electrician
if you are unfamiliar with proper electrical wiring connections. Please
review instructions carefully before proceeding.
WARNING:
Risk of fire or electric shock. Don’t alter, relocate or remove
wiring during installation. Don’t install directly over a heat source.
NOTE:
When first turned on wait about 1 minute for the circuitry
to calibrate. Not for use with dimmers.
F
a
b
c
Put the diffuser (cover) back on
a)
Align one end then slowly press down;
b)
Push the diffuser to the corner of the lamp base;
c)
Lock the diffuser with the aluminium base.
Turn on circuit breaker and the test light.
2.
1.
3.
LINKING INFORMATION
Use provided linking cords to connect multiple
fixtures to one outlet;
Link up the 8 Fixtures;
For protection, place plastic end caps on the ends
of any final fixtures in the linking line.
2.
1.
3.
