The Brighter Choice
EXIT LED SIGN
Install Guide and Manual
CEILING MOUNT
IMPORTANT
1.
3.
5.
7.
2.
4.
6.
8.
9.
10.
The battery in this unit may not be fully charged. After electricity
is connected to the unit, let the battery charge for at least 24
hours before performing any tests. To test, process “TEST” button
and sign should illuminate. Only use LED specified for the fixture
when re-lamping.
EQUIPMENT:
Flat head Philips screwdriver, drill recommended.
Disconnect AC power, make sure the battery is
unplugged before servicing
•
If you are replacing an existing halogen fixture,
allow the fixture to cool away from flammable
materials.
Unsnap canopy hole cover on the top of fixture
Connect leads to AC input leads in the Junction Box.
Black wire for 120V, Red/Orange wire for 277V
•
Cap off unused wires
•
Feed excess wire into a junction box
Connect the battery (see figure)
Unsnap faceplate to open (see figure)
•
For dual-sided EXIT sign, remove backplate
and replace with extra faceplate (included)
Feed lead wires through a hole on the top of the
fixture, ensure wires are secured into wire guides
Attach canopy to j-box using bracket and screws
(included), wires will go through the center hole in
the canopy
•
Snap housing to canopy
Snap-in arrows on EXIT faceplate as required
Secure faceplate to housing
Test after 24 hours of charging
Turn Power OFF
Canopy
Canopy
Battery
Battery
Connector
Socket
Button
CEILING
MOUNT
DIAGRAM
Junction
Box
Bracket
Canopy
Diffuser
Snap-in
Directional Arrow
Exit Panel
Plastic
Housing
Screws
Wire Nuts
