Sun Oracle SPARC T4-1B, Installation Manual

Page: 46 / 58

40 SPARC T4-1B Server Module Installation Guide • May 2012
▼
Assign a Static IP Address to the SP
By default, the server module is configured to obtain an IP address from DHCP
services in your network. If the network your server module is connected to does not
support DHCP for IP addressing, perform this procedure.
To configure the server module to support DHCP, refer to the Oracle ILOM
documentation.
1. Set the SP to accept a static IP address.
2. Set the IP address for the SP.
3. Set the IP address for the SP gateway.
4. Set the netmask for the SP.
This example uses
255.255.255.0
to set the netmask. Your network
environment subnet might require a different netmask. Use a netmask number
most appropriate to your environment.
5. Verify that the pending parameters are set correctly.
-> set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
-> set /SP/network pendingipaddress=
service-processor-IPaddr
Set 'pendingipaddress' to '
service-processor-IPaddr
'
-> set /SP/network pendingipgateway=
gateway-IPaddr
Set 'pendingipgateway' to '
gateway-IPaddr
'
-> set /SP/network pendingipnetmask=
255.255.255.0
Set 'pendingipnetmask' to '
255.255.255.0
'
-> show /SP/network
/SP/network
Targets:
Properties:
commitpending = (Cannot show property)
dhcp_server_ip = xxx.xxx.xxx.xxx
ipaddress = xxx.xxx.xxx.xxx
ipdiscovery = dhcp
ipgateway = xxx.xxx.xxx.xxx