Sun Microsystems Ultra 5, Service Manual

Page: 156 / 258

8-10 Sun Ultra 5 Service Manual • February 2000
FIGURE 8-4
Removing and Replacing a PCI Card From PCI Slot 1 or 3
4. Remove the PCI card from slot 2 as follows (
FIGURE 8-5
):
a. Using a No. 2 Phillips screwdriver, remove the screw securing the bracket tab
adapter to the chassis.
b. Remove the bracket tab adapter.
Caution – To avoid damaging the card’s connector do not apply force to only one
end or one side of the card.
c. At the two corners of the card, pull the card from the PCI riser board connector.
d. Move the PCI card so that the card bracket tab clears the chassis back panel
slot.
e. Remove the PCI card from the chassis.
f. Place the PCI card on an antistatic mat.
PCI card
Screw
Bracket tab
PCI riser board
PCI slot 1
PCI slot 3
PCI slot 2