Sun Microsystems Ultra 5, Service Manual

Page: 116 / 258

6-4 Sun Ultra 5 Service Manual • February 2000
6.2 Cable Assemblies
To remove and replace the diskette drive cable assembly, the hard drive cable
assembly, the serial/parallel cable assembly, and the audio cable assembly, proceed
as follows.
Note –
The Ultra 5 diskette drive cable assembly, hard drive cable assembly, CD-
ROM drive cable assembly, and serial/parallel cable assembly are part of service kit
370-3266; they cannot be ordered separately.
6.2.1 Removing the Diskette Drive Cable Assembly
1. Power off the system, remove the system cover, and attach an antistatic wrist strap
as described in Chapter 5.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
2. Remove the diskette drive cable assembly connectors from the following
(
FIGURE 6-2
):
■
Diskette drive
■
Motherboard (J16)
3. Remove the diskette drive cable assembly from the chassis.