Sun Microsystems Sun StorEdge T3, Installation, Operation And Service Manual

Page: 71 / 148

Chapter 2 Installation 2-33
2.9 Installing the Administration Tools
The Sun StorEdge T3 disk tray can be used with management software, such as Sun
StorEdge Component Manager, to aid in its operation. Component Manager
provides a graphical user interface (GUI) to monitor and manage one or more Sun
StorEdge T3 disk trays that are connected to a host.
The Component Manager software enables you to administer some of the
components of the disk tray, and it constantly monitors system health. Alarm
notification and remote reporting alert the administrator to abnormal activities or
conditions that require attention.
The Sun StorEdge Component Manager Installation Guide provides instructions for
installing the software and also covers the necessary steps to verify the installation,
launch the software, and uninstall the software. The Sun StorEdge Component
Manager User’s Guide describes how to use the GUI to administer Sun StorEdge T3
disk trays.
2.10 Defining and Mounting Volumes
This section includes information on defining and mounting volumes for both a
single controller unit configuration and a partner group. For information on the
commands used in this section, refer to the Sun StorEdge T3 Disk Tray Administrator’s
Guide.
The Sun StorEdge T3 disk tray has been set up with a default RAID 5 configuration.
To view the configuration, use the
vol list
command while in a telnet session
with the disk tray. For example:
In this example:
■
v0
is the volume.
■
143.2 GB
is the total disk space of the volume.
■
5
is the RAID level.
■
u1d1-9
is the number of the disk tray (
u1
) and the numbers of the disk drives
(
d1
through
d9
).
t300
:/:
<1>vol list
volume capacity raid data standby
v0 143.2 GB 5 u1d1-9 none