Sun Microsystems Sun StorEdge T3, Installation, Operation And Service Manual

Page: 55 / 148

Chapter 2 Installation 2-17
2.5 Connecting the Cables
This section explains how to connect cables for both a single disk tray and for a
partner group.
Note –
If you are connecting a single disk tray, skip the steps that start with the
lead-in “Partner group only” and proceed to the next step.
Before you begin, make sure you have all of the required cables and adapters
(
FIGURE 2-10
):
■
Fiber-optic cable, one per unit
■
Media interface adapter (MIA), one per unit
■
AC power cords, two per unit
■
10BASE-T interface cable, 1 per controller unit (not illustrated)
The 10BASE-T cable is not packaged with the disk tray and must be purchased
separately.
■
Interconnect cables, one pair of cables per partner group
Note –
Your Sun StorEdge T3 disk tray packaging might not have included
interconnect cables. If you want install a partner group configuration and do not
have interconnect cables, contact your Sun service representative.