Sun Microsystems STOREDGE A5000, Installation And Service Manual, Page: 96 / 146

7-20 Sun StorEdge A5000 Installation and Service Manual • September 1999
1. Write down the FPM settings for the Loop Type (see Section 5.5),
Box ID (see Section 5.5) and box name (see Section 5.12).
■
Loop Type:
■
Box ID:
■
Box name:
You will need to restore these values later in the procedure.
2. Use the
luxadm remove_device
command to remove the SES path to the disk
array.
For example:
Note –
Do not hit Return until the following step has been completed.
3. Power off the disk array.
# luxadm remove_device box2
WARNING!!! Please ensure that no filesystems are mounted on these
device(s).
All data on these devices should have been backed up.
The list of devices which will be removed is:
1: Box: box6
Please enter 'q' to Quit or <Return> to Continue:
offlining: Drive in "box6" rear slot 1....Done
offlining: Drive in "box6" front slot 2....Done
offlining: Drive in "box6" rear slot 2....Done
offlining: Drive in "box6" front slot 3....Done
offlining: Drive in "box6" rear slot 3....Done
...
Hit <Return> after removing the device(s).