Sun Microsystems StorEdge 3000 Series, Installation, Operation And Service Manual

Page: 97 / 318

Chapter 5 First-Time Configuration 5-19
5.5.1 Viewing the Initial Firmware Windows
You see the initial controller screen when you first access the RAID controller
firmware.
The initial screen is displayed when the RAID controller is powered on.
Note – Since Fibre Channel and SCSI arrays share the same controller firmware,
most menu options are the same. Parameter values might vary according to the
product.
1. Use the up and down arrow keys to select the VT100 terminal emulation mode,
and then press Return to enter the Main Menu.
See “Introducing Key Screens and Commands” on page 7-2 for detailed information
about understanding and using the initial firmware screen.
2. Use the following keys to navigate within the application:
The firmware procedures use the term “Choose” as a shortcut description. Quotation
marks are used to indicate a specific menu option or a series of menu options.
← → ↑ ↓
To select options
Return or Enter To perform the selected menu option or display a
submenu
Esc To return to the previous menu without
performing the selected menu option
Ctrl-L (Ctrl key and L key together) To refresh the screen information
Press a letter as a keyboard shortcut
for commands which have a boldface
capital letter To access a Main Menu command quickly
Procedure Meaning
Choose “menu option.” Highlight the menu option and press Return.
or
Press the key that corresponds to the capitalized
letter in the menu option if one is available.
Choose “menu option 1
→ menu
option 2 →
menu option 3.”
This represents a series of nested menus options
which are selected with arrow keys. Press Return
after each selection in order to access the next
menu item and to complete the series.