Sun Microsystems StorEdge 3000 Series, Installation, Operation And Service Manual

Page: 284 / 318

I-4 Sun StorEdge 3000 Family Installation, Operation, and Service Manual • March 2004
4. Start the Kermit program and set the parameters as shown. Use the device-specific
name for the serial port you are using. In the example, the serial port being
configured is
/dev/tty0p1
.
Note – To return to the Kermit prompt type Ctrl \ and then C. To exit Kermit, first
return to the Kermit prompt and then type
exit
.
I.3 Identifying the Device on Which You
Will Create a Logical Volume
1. Display all the defined disk devices on your system.
A list of defined disk devices is displayed along with information about those
devices.
2. Identify the name of the device on which you want to create a logical volume, for
example,
hdisk7.
# kermit
Executing /usr/share/lib/kermit/ckermit.ini for UNIX...
Good Morning!
C-Kermit 7.0.197, 8 Feb 2000, for HP-UX 11.00
Copyright (C) 1985, 2000,
Trustees of Columbia University in the City of New York.
Type ? or HELP for help.
(/) C-Kermit> set line /dev/tty0p1
( /) C-Kermit> set baud 38400
/dev/tty0p1, 38400 bps
(/) C-Kermit> set term byte 8
(/) C-Kermit> set carrier-watch off
(/) C-Kermit> C
Connecting to /dev/tty0p1, speed 38400.
The escape character is Ctrl-\ (ASCII 28, FS)
Type the escape character followed by C to get back,
or followed by ? to see other options.
----------------------------------------------------
# lsdev -Cc disk