Sun Microsystems StorEdge 3000 Series, Installation, Operation And Service Manual

Page: 219 / 318

Appendix B Using Standalone JBOD Arrays B-5
Refer to the “Monitoring JBODs” appendix in the Sun StorEdge 3000 Family
Configuration Service User’s Guide for information about using these functions with
JBOD arrays.
B.5.1.1 Enabling JBOD Support
Use JBOD support only when you have a JBOD array connected directly to a host.
This enables you to monitor peripheral device condition and events.
Note – Enabling JBOD support may impact I/O performance.
To monitor peripheral device condition and events of a Sun StorEdge FC JBOD array
or Sun StorEdge SCSI JBOD array from the SSCS Console, you first need to enable
JBOD support.
1. Select View
→
Agent Options Management.
The Agent Options Management window is displayed.
2. Select the Enable JBOD Support check box.
3. To immediately display the JBOD array in the main window, you need to probe
for new inventory. Select View
→
View Server and click Probe.
4. Click OK.
The JBOD array is displayed in the main window.
In a single-bus configuration, both ports of the JBOD array are connected to one
HBA on the server, as shown in the following example.