Sun Microsystems Netra t1 100, User And Administration Manual

Page: 129 / 154

Appendix A Installing Additional Memory 107
Installing 4 x 256 Mbyte Memory Boards
This section tells you how to install a stack of four 256 Mbyte memory boards.
Note – The boards you must use for the 4-stack memory installation have the part
number 370-4155. Other 256 Mbyte memory boards (those with part numbers 370-
4096 and 595-5097) cannot be included in a 4-stack configuration. The boards you
must use are identifiable by a sticky label saying ‘4-stack only’.
Note – Do not install memory boards in stacks of three. If you do not want to install
four boards into a system, you can install the boards either singly or in twos.
Materials and Tools Required
The packaging containing your 4-stackable 256 Mbyte memory board includes a kit
(part number 540-4532-02) containing the following (see
FIGURE A-6
):
■
Four square spacers
■
Four lock washers
■
Four flat washer
■
Four long screws (11/16 inch; required only for 4-stack configurations)
■
Four round plastic spacers (required only for 2-stack configurations)
■
Four short screws (3/16 inch; required only for single-board configurations)
■
Four medium length screws (3/8 inch; required only for 2-stack configurations)
SysAdmin.book Page 107 Friday, March 30, 2001 2:38 PM