Sun Microsystems Fire 880, Owner'S Manual

Page: 59 / 236

Chapter 2 Setting Up the System 41
What Next
If you installed a power supply as part of the initial system installation procedure,
resume the procedure at Step 4. See:
■
“How to Install the Sun Fire 880 Server” on page 25
If the operating system has been installed already, and you added a power supply
while the system was powered off, you need to perform a reconfiguration boot. A
reconfiguration boot is required in order for the environmental monitoring software
to recognize the new power supply. See:
■
“How to Initiate a Reconfiguration Boot” on page 55
You can verify correct operation of the power supply by checking the fan and the
LED indicators on the back of the supply. The fan should start spinning and the two
green status LEDs should light within three seconds of completing a hot-plug
installation (or after restoring power to the system).
For more information, see:
■
“About Power Supply LEDs” on page 163