8-8
Sun Fire E2900 System Service Manual • May 2006
FIGURE 8-6
Removing the Power Distribution Board
8.3.2
Installing the Power Distribution Board
1. Make sure that the leveling feet are extended to the floor.
2. Extend and lock the system cabinet stabilizer bar.
See
Section 3.1, “Sliding the System Out of the System Cabinet” on page 3-1
and
Section 3.2, “Sliding the System Into the System Cabinet” on page 3-5
.
Caution –
Failure to extend and lock the stabilizer bar before you slide a system out
of the rack will cause the system cabinet to tip over.
3. Slide the system out of the system cabinet until the locking latches click.
See
Section 3.1, “Sliding the System Out of the System Cabinet” on page 3-1
4. Attach a wrist strap to your wrist. Connect the ESD wrist strap to the system.
See
Section 2.8, “Antistatic Precautions” on page 2-6
5. Align the power distribution board with the card guides. Gently slide it down to
engage with the baseplane (
Summary of Contents for 817-4054-15
