background image

 

 

PROBLEMS WITH YOUR APPLIANCE 

You can solve many common problems easily, saving you the cost of a possible service call. Try the 

suggestions below to see if you can solve the problem before calling the servicer. 

 

TROUBLESHOOTING GUIDE 

PROBLEM 

POSSIBLE CAUSE 

Appliance does not operate. 

Not plugged in. 
The appliance is turned off. 
Circuit breaker has tripped or a fuse has blown. 

Appliance is not cold enough. 

Check the temperature control setting. 
External environment may require a higher setting. 
The door is opened too often. 
The door is not closed completely. 
The door gasket does not seal properly. 

Turns on and off frequently. 

The room temperature is warmer than normal. 
A large amount of contents has been added to the 

appliance. 

The door is opened too often. 
The door is not closed completely. 
The temperature control is not set correctly. 
The door gasket does not seal properly. 

The light does not work. 

Not plugged in. 
Circuit breaker has tripped or a fuse has blown. 
The bulb has burned out. 
The light button is “OFF”. 

Vibrations 

Check to assure that the appliance is level. 

The appliance seems to make too 

much noise. 

Some noise may come from the flow of the 

refrigerant, which is normal. As each cycle 
ends, you may hear gurgling sounds caused by 
the flow of refrigerant in your appliance. 

Contraction and expansion of the inside walls may 

cause popping and crackling noises. 

The appliance is not level. 

The door will not close properly. 

The appliance is not level. 
The door was reversed and not properly 

re-installed. 

The gasket is dirty. 
The shelves are out of position. 

 

NOTE: This appliance is intended to be used exclusively for the storage of wine.

 

Summary of Contents for SWC1840B









Reviews: