background image

 

 

the internal temperature of that zone. 

 

The temperature setting can be adjusted from

 

1

 to 18

 (34°F to 65°F). 

 

3. 

To  view  the  “set”  temperature  at  any  time,  press  either  button 

 

or

 

 

once  and 

the  “set” 

temperature will flash in the LED display for 5 seconds.   

 

RUN

 

Indicator light illuminates to signify the cooling mode is currently in operation. 

 

LIGHT/LOCK

 

 

You can 

turn the interior light ON or OFF by pushing the button marked with the “bulb” symbol. 

The light will turn off automatically if it remains ON for 10 minutes. Pushing the button marked with 
the “bulb” symbol again will turn the light back on. For optimum storage of wine, keep the light off 

except when viewing.   

 

If you press and hold the 

 button for 3 seconds, the control panel will lock and cannot be 

operated again until the button is pressed again.   After that, it will operate normally.   

Temperature Conversion 

This unit has the option to display temperatures in either Celsius or Fahrenheit. To change the setting, 

press and hold both buttons (

  and 

) simultaneously for approximately 3 seconds. 

 

NOTES:   

 

If the  unit  is unplugged  or  turned  off, or  if  there  has  been  a  power  failure,  you  must  wait  3  to  5 
minutes before restarting the unit. If you attempt to restart before this time delay, the appliance will 
not start.   

 

When you use the appliance for the first time, or restart it after it has been shut off for a long time, 
there could be a few degrees variance between the temperature you select and the one indicated 
on the display. This is normal and due to the length of inactivation time. Once the appliance has 
been running for a few hours, everything will be back to normal. 

 

You may notice condensation on the outer surface of the glass door. This occurs when water vapor 
from the air contacts the cold surface of the door and the vapor condenses on the glass, causing a 
fogging effect. In extreme situations, water can even drip off the door, indicating excessive humidity 
in the environment. 

 

If the appliance has been off for less than 5 minutes, the compressor will not restart at once when 

  is pressed. This behavior is built into the control system to protect the compressor.   

 

 

CALIFORNIA CARB/SNAP DISCLOSURE

 

For products manufactured after January, 1, 2019:

 

Retail food refrigeration equipment manufactured after January 1, 2019, designed to store and 

display chilled goods for commercial sale, and that use HFC-134a/R134a refrigerant are not

 

for sale 

in California.

 

*This product uses eco-friendly hydrocarbon refrigerant and fully complies with California CARB 

regulations. However, we are required by California Law to provide the previous disclosure 

statement in every product sold in California.

 

This product does 

not 

use any refrigerants on the “List of Prohibited Substances.”

 

 

Summary of Contents for SWC1840B









Reviews: