8
for energy saving. Even for built-in installation
•
NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Do not install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
, it is a must to keep at least 3/16” (5mm) of space on
each side, 2” (50mm) at the back and 1/16” (1.6mm) at the top to ensure proper service access and
ventilation. And the air vent at the front of the appliance must never be covered or blocked in any way.
•
Avoid locating the unit in moist areas.
•
Plug the Wine Cellar into an exclusive, properly grounded wall outlet. Do not under any circum-
stances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or grounding should be directed toward a certified electrician or an authorized service center.
This unit is designed for either built-in or free-standing installation. If you plan to use the unit in a built-in
application,use the following dimensions for the enclosure:
BUILT-IN CABINET INSTRUCTIONS
Model
SWC1535B
SWC1102
SWC1875B
SWC1926/SWC1966
Width
15¾” / 40 cm
23.8” / 60.5 cm
23.8” / 60.5 cm
23.8” / 60.5 cm
Depth
24¾” / 63 cm
24¾” / 63 cm
24¾” / 63 cm
28½" / 72.5 cm
Height
34¼” / 87 cm
58¼” / 148 cm
69
⅞
” / 177.5 cm
69
⅞
” / 177.5 cm
ELECTRICAL CONNECTION
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For
personal safety, this appliance must be properly grounded.
This appliance requires a standard 115/120 Volt AC 60Hz three-prong grounded electrical outlet. Have
the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or
dangling.
The appliance should always be plugged into its own individual electrical outlet which has a voltage rating
that matches the rating label on the appliance. This provides the best performance and also prevents
overloading house wiring circuits that could cause a fire hazard from overheating. Never unplug the
appliance by pulling on the power cord. Always grip the plug firmly and pull straight out from the
receptacle. Repair or replace immediately all power cords that have become frayed or otherwise
damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end.
When moving the appliance, be careful not to damage the power cord.
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by a qualified electrician or an authorized service center.